To build the Firefly Pro you are going to need a few bits and bobs. Take some time to get everything shown on the picture below so you can build without a hassle.

 

Some of the screws aren't necessary in the exact length shown below. Most of them can be a bit longer or even a little bit shorter. Its just a guideline so you know where to start.

For the main frame you will need to print the parts below.

Print the main frame with 25% infill. The sides and bumper are best printed with 50% infill. However the bumper will be heavily penetrated in a crash so you better print a few spares.

Take the bumper and start screwing in 4 M3x10MM screws. Next take the two M2x12MM screws and screw them in the two holes at the end. Take the lower plate and fasten it to the bumper.

Add two more M2x10MM screws into the holes for the sides. Now holding the side against the lower plate fasten all four M2 screws.

Have fun building and flying the Firefly Pro.

 

FIREFLY PRO GUIDE

You can download the necessary parts yo need for this build on Thingiverse. Just follow the link below

Hardware

Main Frame

Gettins started

Adding the arms

Now to add arms to the Firefly Pro we need a few more printed parts. Get everything ready thats shown on the picture below.

Make sure you orient the ESC mount so the closed sides of the cable outlet is to the front and back to protect the cables.

Start by screwing in all four ESC mounts to the lower plates. Take four more M3x10MM and four M3x8MM screws.

Now fasten all four arms with four M3x10MM screws to the top plate and position it on top of the frame. Align the arms and start screwing in the top plate with the arms into the ESC mounts.

Now fasten all the remaining screws and add the M3x22MM Stand offs with the four M3x6MM screws.

Copyright @ All Rights Reserved

Camera plate

To add the camera plate you will need 4 rubber dampeners and the printed camera plate. To mount the camera plate you need to insert the dampeners into the 6MM holes in the top plate.

Now add the camera plate by inserting the dampeners into the plate. This can be quiet fiddly.

A good way to insert them is to get something like nylon string, put it through the hole and around the dampener. Then gently pull the dampener trough while wiggeling a bit.

 

Done